Check engine light on? Get clear answers about what’s happening and what your vehicle needs.
At SuperTech Auto Repair in Victoria, our Red Seal technicians use advanced diagnostic equipment to investigate engine and emissions faults. We explain the findings and your repair options so you can make an informed decision.
Visit our shop at 677 Burnside Road East, serving drivers throughout Victoria, Saanich, Esquimalt and Oak Bay.
Call (250) 385-7033 to book your check engine light diagnosis.
Is It Safe to Drive With the Check Engine Light On?
A steady light: If your vehicle is running normally and no other warning signs are present, arrange diagnostic testing soon and follow the guidance in your owner’s manual. A steady light still needs attention, even when you cannot feel a difference in how the vehicle drives.
A flashing light: A flashing check engine light can indicate an active misfire that may damage the catalytic converter. Avoid hard acceleration, pull over somewhere safe and call for advice before continuing.
If your vehicle is also shaking, losing power or overheating, stop safely and seek assistance. Tell our team what the light is doing and describe any other symptoms when you call.
Free Check Engine Light Scan and 15-Minute Consultation
Our current Victoria promotion includes a free basic code scan and a 15-minute consultation. We retrieve the stored trouble codes, explain what they may indicate and discuss the recommended next step.
A basic scan provides a starting point. Confirming the cause may require additional diagnostic testing, which is separate from this offer. Ask our team about the scope and cost of further testing before proceeding.
Applies to most vehicles; heavy-duty diesel and certain European models are excluded. Limited to one vehicle per customer, per visit. Advanced or pinpoint diagnostic testing is excluded. Appointments are recommended; walk-ins are accepted as time allows. Cannot be combined with other offers.
View our current Victoria service offers.
How We Diagnose a Check Engine Light
A trouble code identifies a condition detected by your vehicle’s computer. Further investigation helps establish why that condition occurred and which repair is appropriate.
Our “vehicle diagnostics service” may include:
- Reviewing your symptoms. We ask when the light appeared, whether it comes and goes, and how the vehicle has been running.
- Retrieving stored fault codes. We use diagnostic equipment to identify the faults recorded by the vehicle.
- Examining live data and testing relevant systems. Depending on the concern, this can involve checking sensors, wiring, ignition components or other related systems.
- Explaining the findings. We review the test results, relevant photos and recommended repairs with you before repair work is approved.
This process helps establish the cause and supports a repair recommendation based on testing.
Common Causes of a Check Engine Light
Possible causes include:
- Ignition misfires involving spark plugs, coils or other engine problems.
- Oxygen sensor or mass airflow sensor faults.
- EVAP system leaks, including an improperly sealed or damaged fuel cap.
- Air leaks involving intake components or vacuum hoses.
- Catalytic converter efficiency faults.
- Thermostat or coolant temperature sensor concerns.
- Wiring and electrical problems affecting monitored components.
Similar symptoms can have different causes. Testing helps determine which issue applies to your vehicle.
Where repairs are needed, our Victoria shop provides related “engine repair” and “automotive electrical repair” services.